How do I fix code P0124?

What repairs can fix the P0124 code?

  1. Repairing or replacing the TPS connector open or shorts.
  2. Repairing the wiring open or short circuits as necessary.
  3. Replacing the TPS with a new sensor.

Where is throttle position sensor A?

A throttle position sensor (TPS) is a sensor used to monitor the air intake of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle.

Can a throttle position sensor be intermittent?

Generally, the way a bad throttle position sensor causes driveability issues is by intermittently misjudging the position of the throttle. The ECU may sometimes read a half-open throttle when in fact it is partially depressed.

How do I fix code P0123?

What repairs can fix the P0123 code?

  1. Repairing or replacing the TPS connector for shorting.
  2. Repairing the wiring short as necessary.
  3. Replacing the TPS with a new sensor.

How much does it cost to replace a throttle position sensor?

The average replacement cost for the throttle position sensor is anywhere from $110 to $200. The parts cost is anywhere from $75 to $105 while the labor cost is anywhere from $35 to $95.

What happens when throttle position sensor fails?

What happens when my throttle position sensor goes bad. When a TPS goes bad, then the car’s throttle body won’t function properly. It could either stay shut or it won’t close properly which is a severe issue. If it stays shut then your engine is not going receive air and it won’t start.

What causes P0123 code?

If the engine computer receives a signal from the TP sensor that exceeds the maximum limit for a set period, a P0123 code may get registered by on-board diagnostics. Code P0123 may be triggered when your car computer receives a signal from the TP sensor that exceeds the maximum limit for a set period.

What can cause a TPS code?

What are the Possible Causes of the P0122 Code?

  • A loosely-mounted throttle position sensor.
  • Electrical short on the sensor circuit, either to the ground or to another wire.
  • Faulty sensor.
  • Faulty throttle position switch.
  • Bad or corroded wiring or connections for the sensor.
  • Issues with the PCM.

Can a bad throttle position sensor cause a car not to start?

How do you reset the throttle body on a Volvo?

Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.