How do I enable RRAS?

You may right-click the server, and then click Disable Routing and Remote Access. Click Yes when it is prompted with an informational message. Right-click the server, and then click Configure and Enable Routing and Remote Access to start the Routing and Remote Access Server Setup Wizard. Click Next.

How do you check Rras logs?

Answers

  1. To enable RAS logs run command “netsh ras set tracing * enabled”
  2. Now run the scenario that is failing.
  3. Now flush the RAS logs by “netsh ras set tracing * disabled” command.
  4. Check the logs at %windir%tracing directory (example path C:\windwos\tracing) .

How do I install and configure a virtual private network server on Windows Server 2008 R2?

How to Install VPN on Windows Server 2008 R2

  1. Install the Role “Network Policy and Access Services” with the Server Manager.
  2. Select the Role Services “Routing and Remote Access Services”
  3. Configure and Enable Routing and Remote Access in the Server Manager.

What is Rras in network?

RRAS is a software router and an open platform for routing and networking. It offers routing services to businesses in local area network (LAN) and wide area network (WAN) environments or over the Internet by using secure VPN connections.

Is IIS required for RRAS?

RRAS: Features are managed in the Routing and Remote Access console. The Remote Access server role is dependent on the following features: – Web Server (IIS): Required to configure the network location server and default web probe.

How install and configure RRAS?

On the Select Server Roles page, select Network Policy and Access Services, and then click Next twice. On the Select Role Services page, select Routing and Remote Access Services. On the Confirm Installation Selections page, click Install. On the Installation Results page, review the status, and then click Close.

Where are routing and remote access logs?

RRAS log files are written to the %windir%\tracing folder. Use this procedure to control the amount of detail that RRAS writes to the log files. Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.

Which has terminated the reason code returned on termination is 631?

Reason code 631 means “THe port was disconnected by the user.” THat could mean a number of things.

Which of the following protocols are supported in RRAS?

RRAS included two unicast routing protocols, Routing Information Protocol (RIP) and Open Shortest Path First (OSPF) as well as IGMP routing and forwarding features for IP multicasting.

How do I add Nat to routing and remote access?

Right-click the server, and select Configure and Enable Routing and Remote Access.

  1. When the wizard opens, click Next.
  2. Select Network address translation (NAT) and click Next.
  3. Select the network interface that your users will use to connect to the internet, and then click Next.