How do I access the Netgear switch web interface?

In the web browser, enter http://192.168.0.239. This is the default IP address of the switch….To gain full access to your NETGEAR Smart Managed Pro switch without registering:

  1. Connect your computer to the switch using an Ethernet cable.
  2. Power on the switch.
  3. Launch a web browser on your computer.

Does a Netgear switch have an IP address?

The switch gets an IP address from a DHCP server (such as your router) by default. If your switch is not connected to a DHCP server, use the default IP address: 192.168. 0.239.

How do I configure Netgear switch?

Download the latest firmware for your switch from the NETGEAR support site and install it. Connect a computer to your switch’s local management interface and enable Insight management mode. Add your switch to Insight and start configuring it. (Optional) Configure settings that cannot be managed in Insight.

How do I access my NETGEAR access point?

Open an internet browser. In the browser address bar, type the default IP address of your AP (for example 192.168. 0.100) and hit enter….Discover the IP subnet of the existing LAN:

  1. Connect a computer to the existing LAN.
  2. On a Windows PC, open a command prompt.
  3. In the command prompt, enter the command ipconfig.

How do I find the IP address of my Smart switch?

Locating the IP address of your Linksys Smart Gigabit Switch using a Linksys gigabit VPN router

  1. Log in to your router’s web-based setup page using your router’s IP address.
  2. On the main screen, click Configuration.
  3. Click the DHCP on the left panel.
  4. Click DHCP Status.

How do I connect my Netgear switch to my computer?

  1. Connect the equipment. Connect Port 5 on the switch to your router. Connect Ports 1–4 on the switch to your power over Ethernet (PoE) or non-PoE devices.
  2. Connect to power.
  3. Check the status.

How do I find the IP address of my access point?

How to find the IP address of an Access Point?

  1. Start > Run > type: cmd (to enter command prompt)
  2. Type: ipconfig /all.
  3. In the list, find the line that is your “Default Gateway”, this is your primary router/access point.