Does a gas water heater need a ground wire?

Does a Water Heater Need to be Grounded? A water heater does not need to be grounded, though. It is recommended. Using a bonding wire to ground the cold and hot water pipes to the home help prevent pipe corrosion and the steel water heater.

How do you check the pilot light on AO Smith?

Press down on the ignitor button while holding the red set button, until you see the pilot light come on.

Can I install a hot water heater myself?

Installing a water heater is no average DIY project. You must have plumbing, electrical, heating ventilating, and carpentry skills, know state and local building codes, obtain a permit for the work and arrange with your municipality for an inspection of the work.

What is the green wire on a hot water heater?

Electrical Connections for a 50Gal Water Heater The bare ground wire of the incoming circuit is bent into a clockwise hook shape and placed under the green ground screw and secured tightly. This screw is located inside the water heater junction box, or the water heater may have a green ground wire that may be used.

Does the red wire go to the white wire on a hot water heater?

If the incoming electrical circuit wiring does not have a separate red wire, then the white wire may be used as the second 120 volt circuit of the 2-pole 240 volt circuit, and should be indicated with a black or red wrap of electrical tape of permanent marker.

How do I reset my AO Smith gas valve?

How to Reset Your A.O Smith Water Heater

  1. Go to the electrical panel for your home which is located in the garage or on the exterior walls of the house.
  2. Head to your hot water tank.
  3. Press the reset button.
  4. Return to the electrical panel to flip the breaker switch to the on position.

Where is the reset button on AO Smith water heater?

To perform an AO Smith water heater thermal switch reset, you will need to reset the entire unit. To do this, open the electric panel on the water heater and remove any insulation that is behind the panel. You will then press the red button, hear it click, then the reset will complete.