Do I need a shower curb with a shower pan?
Do I need a shower curb with a shower pan?
Installed properly, you’ll be fine – but if you don’t plan it well, you could have some pretty big problems with water and your curbless shower. Without a curb, the shower water isn’t contained in the tub area and can get EVERYWHERE.
How do you slope a Curbless shower floor?
Sometimes less slope is specified in a curbless shower, such as 1/8” per foot. In some jurisdictions, a slope of 3/16” per foot or 1/8” per foot could be allowed for a roll-in shower designed to comply with the Americans With Disabilities Act (ADA).
How much space is needed for a curbless shower?
NC State University says that most national codes permit curbless showers as shallow as 30 inches by 60 inches; however they suggest a minimum depth of 36 inches. A shower that is 5 feet by 5 feet will allow sufficient space for both the wheelchair user and an aide.
What can I use for shower curb?
It’s just as easy with a concrete floor, stack about two or three concrete bricks in your desired shape. You can attach them to the floor and together with regular thinset. Check to ensure that the height of your curb does not tamper with your shower door.
Where should the drain go on a curbless shower?
“For curbless, we recommend placing the drain either across the whole entrance wall—not just the doorway—or across the whole wall opposite the entrance,” Van Landingham says. A drain that’s too narrow, or one that only spans the doorway, will cause water to pool or flood beside walls and in corners.
Do Curbless showers leak water?
The short answer is no. If you have a proper shower design and installation, you shouldn’t have any problems. A properly installed curb-less shower will have a floor slope of about 1½ to 2”. This prevents the water from spilling out all across the bathroom and is essential for draining.
Where does the linear drain go in a curbless shower?
Drain location: Installing the linear drain at the shower entry is the easiest installation for a curbless shower, because the subfloor is not required to be recessed. The latter means there is no need to raise or lower the shower or bathroom floor to hide the slope.
