Can you use Dektol for film?

Yes, you can use Dektol for film development. Dektol uses the same developing agents as D76, metol and hydroquinone, but the accelerator used by Dektol (Sodium Carbonate) is much stronger that the one used by D76 (Sodium Sulfite).

What is the purpose of the developer Dektol?

DEKTOL PAPER DEVELOPER is Kodak’s standard developer for tray processing. Produces neutral or cold tones with cold-tone papers and warm tones with warm- tone papers. Offers high capacity and uniform development rate. Also for use with some films.

What is Dektol in photography?

NOTE: Dektol is a cold tone developer. A low contrast developer like Selectol Soft favors lower contrast, subtle middle gray tones, and warmer print color when compared to Dektol. The sequential use of the two developer baths al- lows for specific control of shadows and highlights in the developing process.

What is Kodak D 76?

D-76 provides full emulsion speed and excellent shadow detail with normal contrast, and produces fine grain. One gallon mix is in powder form and must be mixed with water before use. You’ll find it an excellent choice for almost any general photo application.

How do you use Kodak Indicator Stop Bath?

To prepare your stop bath, dilute Kodak Indicator Stop Bath 1+63. That means one part stop to sixty-three parts water. The dilution is the same for both paper and film processing. Make sure you mix together thoroughly before use.

How do I use XTOL developer?

Using Diluted Developer You can dilute XTOL Developer 1:1 with water (developer:water) for one-shot (single-use) processing. Dilution at 1:1 will provide slightly greater film speed, enhanced sharpness and shadow detail, and slightly more grain. Use diluted developer only once.

How many times can you use D76?

How many times can you reuse D76 developer? At stock concentration, D76 can be reused. If diluted at 1:1, 1:3 or 1:5, it is cannot be reused. The general rule is that you add 10% to the development time per reuse.

How do you dilute Kodak stop bath?

How do I mix my Kodak fixer?

In mechanized processors, the mixed solution is used as both a replenisher and a working solution. KODAK DEKTOMATIC 65 Paper Processor To use this fixer in the KODAK DEKTOMATIC 65 Paper Processor, dilute one part Solution A to three parts water. Fix resin-coated papers at 30°C 86°F for 25 seconds.

Is XTOL a one-shot developer?

Xtol can either be used as a stock solution, or it can be diluted further with water for one-shot processing. You can dilute 1+1. That means one part stock solution to one part water.