How do I reset my Yamaha RX v1600?

Now to initial factory settings (pg. 90), go to “ADVANCED SETUP” procedure section, set “User Preset” function for “RESET”. Next time system power is turned on it will automatically reset to factory settings.

How do I get sound on my Yamaha receiver?

First, power off the AV Receiver/Sound Bar and TV, disconnect all the HDMI cables, and unplug the power cables. After five minutes, reconnect HDMI cables and power cables. Next, please check the following 3 points. Check the setting of HDMI Control on AV Receiver/Sound Bar.

How do I get my Yamaha receiver out of standby mode?

It has a reset manually by holding down SPEAKERS A AND BASS+ TOGETHER AND THEN PUSH POWER BUTTON. MIGHT CAN HELP.

How do I test my Yamaha receiver speakers?

RX-V375 Using the Speaker Test Tone

  1. Press the Setup Button.
  2. The On Screen Menu will pop up on your TV screen.
  3. Us the Arrow Up/Down buttons to navigate to Speaker if it is not already high lighted.
  4. Press the Enter button.
  5. Configuration should be highlighted.
  6. Arrow Down to Test Tone and press the Enter button.

How do you troubleshoot a receiver?

How to Fix a Stereo Receiver That’s Not Making Sound

  1. Check the power. Ensure that all plugs are firmly seated in their respective sockets because sometimes a plug can slip out halfway and not draw power.
  2. Check the speaker/source selection.
  3. Check the speaker wires.
  4. Check the speakers.
  5. Check the source components.

Why is my receiver on standby?

Your receiver has probably gone into protect mode. Have you had recent power surges or lightning strikes? That could cause this problem. Try disconnecting all the inputs and the speakers, then turn the receiver on again.

What is standby mode on a receiver?

You can set the receiver to switch to standby mode automatically when you do not operate the receiver or when no signals are input to the receiver.

Why is my receiver not putting out sound?

Causes of a Stereo Receiver Not Making Sound Silent stereos are usually caused by low power, a wrong source selection, disconnected or faulty speaker wires, broken speakers, or a malfunctioning source component.

How do I fix my stereo receiver that won’t turn on?

Manuals are posted on your model support page.

  1. Securely plug your device to a working wall outlet.
  2. Press and hold the POWER button, and unplug it from the wall outlet at the same time.
  3. Release the POWER button.
  4. Make sure that your device has enough ventilation.
  5. Plug your device back into a wall outlet.