How do you turn on the ice maker on a GE bottom freezer?
How do you turn on the ice maker on a GE bottom freezer?
ON and OFF are labeled on the icemaker. Slide the switch to the right to turn the icemaker OFF. Slide the switch to the left to turn the icemaker ON.
Why is my bottom freezer not making ice?
If your ice maker isn’t producing ice at all or is producing crescents or cubes that are smaller than usual, it’s typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line. Fix: To repair a frozen line, slide the refrigerator and unplug it.
How do I reset my bottom freezer ice maker?
The test switch, also referred to as the reset button, is located, in the front of the ice maker, underneath the Ice Tray Motor Housing, past the front cover. Press and hold the button until you hear the Ice Tray Motor begin to torque, then release. 3. Close the freezer door and wait twenty-four hours for full results.
How do I reset my GE refrigerator ice maker?
Tips for Resetting a GE Ice Maker
- Adjust the feeler arm. If water doesn’t immediately start filling in the reservoir, go to step 2.
- Press the on/off button.
- Keep the ice maker unplugged for 15 minutes.
- Turn the ice maker back on.
Why is my GE refrigerator ice maker not making ice?
If a GE ice maker isn’t making ice, it may be too warm. GE recommends that the freezer should be set to 0 to 5 degrees Fahrenheit for ice production. If it’s too hot, ice may not produce well or appear smaller or misshapen. On the other hand, if it’s too cold, ice may build up and frost will prevent ejection.
Why is my GE ice maker not working?
The icemaker must reach a temperature of 16 degrees F before a cycle will begin. If the temperature in the freezer is too warm, ice cubes will take longer to form or may not form at all. Try adjusting the freezer temperature a little lower. A low food load in the freezer can affect the production of ice.
Why is my GE refrigerator not dispensing water or ice?
If you discover your GE refrigerator not dispensing water or ice, the dispenser switch may have failed. No voltage, no working dispenser. A multimeter can be used to check for continuity to determine if the dispenser switch is working properly. If there is no continuity, then the switch needs to be replaced.
