What is ENC28J60?

The ENC28J60 is a stand-alone Ethernet controller with an industry standard Serial Peripheral Interface (SPI). It is designed to serve as an Ethernet network interface for any controller equipped with SPI. The ENC28J60 meets all of the IEEE 802.3 specifica- tions.

How connect ENC28J60 to Arduino?

Control LED on the Internet using Arduino & ENC28J60 Ethernet Module:

  1. Download the Library for ENC28J60 from here: ENC28J60 Library.
  2. Add the library files to your Arduino IDE library:
  3. Copy the code from below and paste it to Arduino IDE.
  4. Compile & then upload the code to Arduino UNO Board:

What is Arduino Ethernet shield?

The Arduino Ethernet Shield allows an Arduino board to connect to the internet using the Ethernet library and to read and write an SD card using the SD library. This shield is fully compatible with the former version but relies on the newer W5500 chip.

What is Ethernet module?

The Ethernet switch network module is a modular, high-density voice network module that provides Layer 2 switching across Ethernet ports.

What is W5100 Ethernet shield?

The W5100 is a versatile single-chip network interface chip with a 10/100Mbs Ethernet controller integrated internally. It is mainly used in a high integrated, high stable, high performance and low cost embedded system. The W5100 enables you to connect to the Internet without operation system.

How do I use an Arduino Ethernet shield?

How to use Arduino Ethernet Shield 2

  1. Stack Ethernet Shield 2 on Arduino Uno or Mega.
  2. Connect PC to Arduino Uno/Mega via USB cable.
  3. Connect Ethernet Shield 2 to router/access point via Ethernet cable.
  4. Open Arduino IDE and write code.
  5. Upload the code to Arduino Uno/Mega.

What is Wi Fi module?

WiFi module, also known as serial to WIFI module, which belongs to the transmission layer of IoT. The function is to convert serial port or TTL level into embedded module which can conforming to WiFi wireless network communication standard, with built-in wireless network protocol IEEE802.

What is the switch module?

Switch Module . Switch Module 2000 (SM2000)” means a Module Control/Time Slot Interchange Unit along with a number of Peripheral units and related Software added to an embedded 5ESS-2000 Switch or to an existing RSM site.

What pins does Ethernet shield use?

Pins Used / Shield Compatibility The Ethernet shield uses digital pins 11, 12, 13, 10, and 4 for SPI communication with the W5200 Ethernet controller and SD card. Therefore, the shield is compatible with any other shield that does not use pins 10, and 4 in this regard.