What causes loops on top of machine embroidery?

Looping is usually caused by thread tensions that are too loose. It could occur either on the top or bottom of the design. Both bobbin and tensioner could be the culprit. Check if the problem is caused by tensioners by turning tensioner knobs to the right to tighten.

Why is my top thread looping on top?

Looping on top generally means the needle tension is too loose. Change your needle. The golden rule for needle selection is to use the smallest sharpest needle that can carry the thread through the fabric without damage to the thread, fabric, or needle.

Why are there loops in my stitches?

Looped stitches are usually caused by improper tension. If the loop is on the upper side, it may be corrected by loosening the top tension or by tightening the lower tension. If the loop is on the under side, it is usually best corrected by adjusting the upper tension.

Why is my bobbin thread showing on top of my embroidery?

In general, if you are seeing bobbin thread in your top stitching, the bobbin tension is too loose. This little screw on your bobbin housing allows you to adjust your bobbin tension. Don’t overdo it though!

How do I stop embroidery flagging?

Use the smallest hoop possible for the pattern to minimize flagging. If an adhesive tape is used, make sure it holds the fabric firmly in place to minimize flagging. Note: flagging is when the material moves up with the needle minimizing the size of the needle loop which can cause excessive skips and thread breakage.

Why is the thread looping under my fabric?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

Why is my top thread looping on the bottom?

What should the tension be on an embroidery machine?

When doing machine embroidery, the tension dial should be set somewhere between 2 to 6. If the stitches appear loose, turn the tension up one notch and embroider again.