How much resistance should an oven igniter have?

between 80 and 175 ohms
The Oven Igniter If it shows resistance, it has continuity. No resistance? No continuity. Typically these will be somewhere between 80 and 175 ohms of resistance for a working igniter.

How does an oven safety valve work?

Modern burner ovens now feature a gas safety valve to prevent an explosion when unlit. Unless ignited by an electric glow bar, pilot flame or electric spark with a gas supply, the valve will remain closed. Gas Safety Valves: Safety should be you’re top priority when you’re working with gas.

How do you test an igniter with a multimeter?

Test The Ignitor With A Multimeter Set a multimeter to the lowest possible resistance test and place the probes onto tips of the plug for the ignitor. If the multimeter shows infinity or stays at zero, the ignitor no longer works and must be replaced.

What is the Ohms of an oven igniter?

With a multimeter set to OHMS, connect to both igniter leads. On a good igniter, there should be between 40 & 400 OHMS. A bad igniter will show no resistance or continuity.

How do you test a gas oven control board?

A properly working control should have a lit-up display and respond to commands. If the display is not lit, test the hot neutral going to the control for 120 volts. If 120VAC +/- 10% is present at the control, the control should be replaced.

Why is my oven not getting up to temperature?

If you notice that your electric oven isn’t heating up to the correct temperature and food comes out under-cooked, this many be caused by a defective electric oven thermostat. Thermostats measure the temperature inside the oven cavity, switching the electric element on and off to maintain the desired temperature.

Why won’t my oven work but burners do?

Electric Oven Won’t Turn On But Burners Work The element may be burned out. You can check this by unplugging the stove (or shutting off the breaker), removing the element, and performing a continuity test. If it passes, look for loose wires or connections and perform a test on the thermostat control.

What is the ohm reading on an ignitor?

between 37-68 ohms
Resistance should be between 37-68 ohms. If the igniter and the surrounding air are at about 70°F and the igniter wires are not connected to any other electrical components, the resistance of the igniter should not exceed 75 ohms. If it does, the igniter should be replaced.