Why is my Aurora shredder not working?

The shredder does not power on or work at all. Make sure that the unit is securely plugged into a working outlet / socket. If you have been continuously shredding for an extended period of time, the unit may have overheated and the thermal protection feature has been activated to shut off the machine.

Why does my paper shredder not work?

If this doesn’t help or your shredder doesn’t have a reverse function, try turning it off and unplugging it. Dust-free paper shredder blades. Turn on your paper shredder again and check if the paper shredder is unjammed. If it is, also lubricate the paper shredder blades to make sure the cutting blades run smoothly.

How do you reset a shredder?

b) The shredder may need to be reset. Switch it to the reverse (R) position for 2 seconds and then back to auto (I). This should reset it and it will operate again.

How do you clean a shredder sensor?

Once you locate the sensors, use a cotton swab dampened with rubbing alcohol to wipe away any residue or dust. You may need to clean it a couple of times. Also if there is any visible paper debris in this area, remove with cotton swab or needle nosed pliers.

Do shredders wear out?

Regardless of the pattern, shredders have metal blades that cut the paper into shapes. As the blades cut through paper, they create dust that builds up and causes the blades to wear down. Users must clean and maintain the blades to keep the shredder functioning well.

Why does my shredder keep stopping?

If this occurs, chances are your shredder just needs a break. Most of the smaller ones lack continuous-duty motors and can need as many as 20 minutes before they’re ready to go again. You should also check to see if the machine is jammed or if the waste basket is full.

How often do you need to lubricate a paper shredder?

If you use your shredder occasionally, then oiling your shredder may only be necessary every two months to maintain good performance. If you use your shredder a lot, however, then your best practices are to oil your cross cut shredder every time you empty the waste bin.

How do you fix a clogged paper shredder?

How to un-jam a shredder

  1. First things first, unplug the shredder.
  2. Empty the shredder.
  3. Switch to reverse.
  4. If the shredder is still jammed, switch back to forward.
  5. Decrease the amount of paper you put in.
  6. Make sure the shredder is lubricated.

Why won’t my Shredder start?

When ready to shred, be sure to insert material directly into the center area to start the machine (especially applies to smaller pieces of paper… and/or CDs and Credit Cards if applicable). The shredder probably has a paper jam. Please refer to “How to Clear a Paper Jam” The activation sensor in the feed entry is blocked with dust, debris, or oil.

What happens when the Shredder is in “auto” mode?

While in “Auto” mode, the shredder will not run until paper is inserted into the middle of the feed entry slot. The trigger that activates the shredder is located in the center section of the feed entry slot.

How do I know if my Shredder is shredsafe™?

If your shredder is equipped with the ShredSafe™ feature, be sure not to tilt/push open the cover completely beyond the first preset position. If done so, the safety power cut off feature will be activated and the shredder will be inoperable. II. The shredder runs but does not pull paper down. The shredder only cuts the bottom of the sheets.

Can You Spray air on a shredder?

• Do not spray or keep any aerosol products in or around shredder. • DO NOT USE CANNED AIR ON SHREDDER.  CLEANING: • ALWAYS UNPLUG THE SHREDDER BEFORE CLEANING! • Only clean the shredder by carefully wiping the unit with a dry soft cloth or towel.