Is Digisol DG hr3400 dual band?

4) Has two 5dbi antenna’s and provides full signal strength….DIGISOL DG-HR3400 300 mbps Wireless Router (Black, Single Band)

Frequency 2.4 GHz
Frequency Band Single Band

How can I use Digisol as wifi extender?

Select Repeater Enabled and type the Wireless network name under SSID of AP(Main AP) Click Apply to enable the repeater mode. After clicking on apply, you will get the message as shown below. Click on OK to continue. The Router will reboot and you will get the wizard to configure the router as repeater.

What is the default IP for Digisol router?

2. The default IP address of this wireless AP is 192.168. 1.200.

Is Digisol router good?

Bottomline: Digisol DG-HR3400 Wi-Fi Router is available at very competetive price point and delivers good wireless speed. It doenst have USB for load balancing and has average file tranfer speed, yet suitable for users who browse internet and do some extra activities.

How do I secure my Digisol wireless router?

  1. STEP 1: ACCESSING THE WEB CONFIGURATION PAGE OF THE ROUTER. Open the configuration page of the router by typing http://192.168.1.1 in a web browser.
  2. STEP 2: CONFIGURE WIRELESS SETTINGS Click on Network > WLAN. Then click on Basic on the left hand side.
  3. STEP 3: CONFIGURE WIRELESS SECURITY.
  4. Under SSID TYPE, select Root.

How do I find my Digisol router IP address?

Open a web browser and enter http://192.168.1.1. 2. Log into the browser-based utility. The default username is “admin” and the default password is “admin”.

What is repeater router?

A Wi-Fi repeater, extender, or booster is a device that forwards wireless signals from the router to cover a larger area, such as multiple floors of a house. The repeater creates a new network based on signals from the originating network, and the clients that connect to the repeater are thus on a separate network.

How do I bridge my Digisol router?

  1. Bridge Mode. Follow the steps below to configure DG-BG1000 in bridge mode:
  2. Change IP Address. HOW TO CHANGE THE LAN IP ADDRESS OF THE DG-BG1000 ROUTER.
  3. Configure in PPPoE. Configure DG-BG1000 in PPPoE mode.
  4. DDNS. Step 1: Open the configuration page http://192.168.1.1.
  5. DSL Modulation.
  6. Port Forwarding.

What is Digisol username and password?

The default username is “admin” and the default password is “admin”. 3. Choose Setup -> Wizard as shown below.