What is Cisco EEM script?

Embedded Event Manager (EEM) is a technology on Cisco Routers that lets you run scripts or commands when a certain event happens.

What is EEM in networking?

Cisco Embedded Event Manager (EEM) is a feature included in Cisco’s IOS operating system (and some other Cisco OSes such as IOS-XR, IOS-XE, and NX-OS) that allow programmability and automation capabilities inside the device.

What is EEM interface?

The EEM(Embedded Event manager is a software component of cisco IOS, XR, and NX-OS makes life easier for administrators by tracking and classifying events that take place on a router and providing notification options for those events. EEM allows you to automate tasks, perform minor enhancements and create workarounds.

What is EEM applet policy?

An EEM policy is an entity that defines an event and the actions to be taken when that event occurs. There are two types of EEM policies: an applet or a script. An applet is a simple form of policy that is defined in the CLI configuration. A script is a form of policy that is written in Tcl.

How do I run event manager?

Open Run dialog by pressing Windows+R. Type eventvwr. msc (or eventvwr.exe) and click OK. Run Event Viewer in Microsoft Management Console.

How do I stop an EEM script?

If your device does not support “event manager scheduler clear” the only way to terminate a stuck, or long-running EEM policy is to reboot. If your device does not support “event manager scheduler clear” the only way to terminate a stuck, or long-running EEM policy is to reboot.

How do I run event logs?

How do I start an event log?

Start Windows Event Viewer through the command line To open a command prompt, click Start , click All Programs , click Accessories and then click Command Prompt . As a shortcut you can press the Windows key + R to open a run window, type cmd to open a, command prompt window. Type eventvwr and click enter.

How do I turn off applet event manager?

To stop this applet, you can run the command “event manager scheduler clear ID” or “… clear all”. That said, it will not immediately abort. It should abort after the wait before the reload.

How do I check my IP SLA?

Defining and Running an IP SLA Test Operation

  1. Step 1: Enable the IP SLA Responder on the Target Switch. Switch(config)# ip sla responder.
  2. Step 2: Define a New IP SLA Operation on the Source Switch.
  3. Step 3: Select the Type of Test Operation to Perform.
  4. Step 4: Schedule the Test Operation.