How do you reset a pellet stove?

The Pellet Stove Reset Button Once the stove runs out of pellets, it will no longer be able to heat. In this way, you have effectively reset it. Alternatively, you can reset your pellet stove by turning it off, waiting a few seconds, and then turning it back on again.

Why does my king pellet stove keep shutting off?

A pellet stove that keeps shutting off is a sign that the stove requires cleaning, as either the fuel or the air is being blocked from getting the fire. The combustion chamber and hopper should be cleaned thoroughly. A pellet stove shutting off may also signal that a part is worn and needs replacing.

What should my king pellet stove be set at?

Electrical Rating 110-120 volts, 60 HZ, 3.0 Amps Watts (operational) 175 (approx.) Watts (igniter running) 425 (approx.) Your pellet stove is designed to burn premium hardwood pellets that comply with Association of Pellet Fuel Industries standards.

Why are my pellets not burning?

If your pellet stove isn’t burning well If your inlet cap becomes blocked, you might notice that pellets are not burning entirely. Clean the cap manually to make sure it is not blocked, and inspect it for any damage or leaks. A failing inlet cap can be replaced, if needed.

Why is my pellet stove blower not working?

Probable cause: The pellet vent is clogged. Either the motors are dirty or need replacing. If a blower requires replacing, ensure to identify which blower (convection – pushes heat into the home whereas combustion – pushes exhaust outside; or auger motor – feeds pellets into the burn pot).

What is the best setting for a pellet stove?

It is best to run the appliance on the lower heat settings like 2 or 3 rather than up at 4 or 5. The higher heat settings result in lower efficiency and the appliance cycling from high to pilot fire too often.

Why does my pellet stove shut off after 30 minutes?

My Stove Keeps Shutting Down You may have noticed the common causes for most pellet stove problems by now – a dirty unit, and poor air adjustment which won’t provide enough heat to trip the sensors. Also, your pellets might not being feeding into the auger correctly, due to a worn down or broken part.

What does e2 mean on a Ashley pellet stove?

If the unit does not reach its minimum operating temperature within the 20 minute startup period, it will shut down and display the “E-2” code.

Why is my pellet stove dropping pellets but not igniting?

Clean all vents, check and repair/replace all gaskets, adjust damper or airflow setting. Adjust air-to-pellet ratio by increasing air flow. Adjust air-to-pellet ratio by increasing air flow and/or decreasing feed rate. Adjust air-to-pellet ratio by increasing air flow and/or increasing feed rate.