How do I find the HSRP command?
How do I find the HSRP command?
Showing HSRP State Information
- Problem. You want to see current HSRP information, such as which router is primary.
- Solution. To view the HSRP information, use the following EXEC command: Router2# show standby.
- Discussion.
What command displays HSRP configuration and status information?
Related Commands
| Command | Description |
|---|---|
| hsrp preempt | Configures HSRP preemption and preemption delay. |
| hsrp track | Configures an interface so that the Hot Standby priority changes based on the availability of other interfaces. |
| show hsrp | Displays HSRP information. |
Which command is used to verify if the HSRP requirements are met?
Use the show standby command to verify your configuration. There’s a couple of interesting things here: We can see the virtual IP address here (192.168. 1.254).
What is the use of zone pair security command?
A zone-pair is configured for one direction only. Policies are defined in which traffic is identified (what type of traffic) then what action should be taken (Inspect Denied, permit). Then we have to apply this policies to a zone-pair.
How do I configure HSRP on my router?
Configure HSRP version 2 between R1 and R2 using the IP addresses 10.10. 10.1/24 (R1) and 10.10. 10.2/24(R2) and a virtual IP address of 10.10….Table 3 – R2 Example Configuration.
| 1 | Enter privileged EXEC mode. | R2>enable |
|---|---|---|
| 11 | Configure the use of HSRP preemption. | R2(config-if)#standby preempt |
How do you troubleshoot HSRP?
Find the correct source (port) of the MAC address in which the error message reports. Disconnect the port that must not source the host MAC address and check for HSRP stability. Note down and check the STP topology on each VLAN and check for STP failure. Verify the port-channel configuration.
What is a firewall security zone?
A security zone is a group of interfaces to which a security policy can be applied to control traffic between zones. For ease of deployment, the Cisco ISA500 has several predefined zones with default security settings to protect your network.
What is self zone in zone-based firewall?
Cisco automatically designates a special zone for us called the Self Zone. This important zone is used for controlling traffic that is sourced from or directed to the router itself. The zones we create are placed into zone pairs. A great example is having a simple Inside Zone paired with an Outside Zone.
Which among the options is the HSRP state for a router?
1) Initial State: When the Interface goes in up state. 3) Listen State: The router knows Virtual IP address and listens for hello messages from Active and Standby routers. 5) Standby State: This is the router which will become the active router and continuously sending hello messages to active router.
What is Virtual IP in HSRP?
Virtual IP : IP address from local subnet is assigned as default gateway to all local hosts in the network. Virtual MAC address : MAC address is generated automatically by HSRP. The first 24 bits will be default CISCO address (i.e. 0000.0c). The next 16 bits are HSRP ID (i.e. 07.ac).
