How do you make a rescue dummy out of a fire hose?

Page 1

  1. Fire Hose Dummy.
  2. How to make a hose dummy for training.
  3. Roll out 3 lengths 1-3/4 hose and connect.
  4. Bring all lengths tight together.
  5. Make all 6 pieces parallel and upright.
  6. Make the other arm.
  7. Pull one side up into the torso, leaving a long loop for the leg.
  8. Tease one length out of the torso and out into the arm.

How strong is a firefighter hose?

The usual working pressure of a firehose can vary between 8 and 20 bar (800 and 2,000 kPa; 116 and 290 psi) while per the NFPA 1961 Fire Hose Standard, its bursting pressure is in excess of 110 bar.

What is important to do before using a fire hose?

Before you use the hose reel: ⇒ Activate the emergency alarm system in your building. ⇒ Contact the fire brigade by calling 111. ⇒ Alert the designated Fire Warden. ⇒ Verify the fuel of the flame (if it is not a class A fire, do not use a hose reel).

What material is fire hose made of?

nylon fabrics
Today’s fire hoses are typically made of woven nylon fabrics and various types of rubber. They vary in weight, length, purpose, and use.

Can fire hoses break bones?

One of its metal couplings struck Rae in the leg and broke the bone, like it was nothing. In the middle of a fire in Dumbarton, Scotland, a rogue hose burst, uncoiled, and bowled over five goddamned firefighters in one shot.

What is the correct order of operation for using a fire hose?

Using the reel: ⇒ Turn on the valve. ⇒ Reel the hose out until you have enough length to reach the flame. ⇒ Move the nozzle into the open position to allow the flow of water. ⇒ Aim the stream of water at the base of the fire, always from a safe distance.

What is the acronym PASS?

It’s easy to remember how to use a fire extinguisher if you can remember the acronym PASS, which stands for Pull, Aim, Squeeze, and Sweep. Pull the pin. This will allow you to discharge the extinguisher.

How do you hold a fire hose?

One reliable stance firefighters use is a low kneeling position where the underside of the hose is grasped by both hands (at arm’s length from the nozzle), a friction point under the armpit, and another friction point on the inside hip.

What are the types of fire hose?

Delivery hose is divided into two sub-categories: percolating hose, and non-percolating hose. Percolating hose allows water to seep through the hose and is used mainly to fight forest fires.