How do I set up my Okidata 320 Turbo?

Install the Okidata 320 Turbo driver for Windows Double-click on Add Printer. The Add Printer Wizard will start. Follow the instructions to complete installation of the driver. Be sure to print a test page to verify that the driver has been installed and that the printer has been hooked up correctly.

How do I align my Okidata printer?

Press and hold the Tear Key to see where it will print. To adjust, while sill holding the Tear Key down, press and hold the Shift Key. Release the Tear Key and then press and hold either the Micro Feed Up or Micro Feed Down Key down until it gets to where you want to print.

How do you set tear off on Okidata 320?

To change the Forms Tear-Off setting: 1 Press SEL (1) + SHIFT (2). 3 Press ITEM (4) until Form Tear-Off appears in the second column. 4 Press SET (5) until the time interval you wish to select appears in the third column.

How do I load paper into Oki printer?

Loading Paper

  1. Pull the paper cassette out.
  2. Set the paper size dial (1) to match the loading paper size.
  3. Slide the paper guide to the width of paper to be loaded.
  4. Slide the paper stopper to the length of paper to be loaded.
  5. Fan a stack of paper well, and then align the edges of the paper.

What is tear off in printer?

ANSWER. Form tear off’ refers to the perforated edge of the paper. This setting sets the page to tear off in the same position after every print. NOTE: Switching the printer OFF does not save the new settings.

How do you put paper in an MP tray?

Load Paper in the Multi-purpose Tray (MP Tray)

  1. Open the upper cover (1) and MP tray (2) using the finger holds on each side.
  2. Using both hands, pull up the paper tray until it locks into place.
  3. Lift up the paper support.
  4. Gently press and slide the MP tray paper guides to match the width of the paper you are using.

How do you print continuous paper?

Turn the printer off; then remove the printer cover and the paper guide. Next, remove the paper tension unit by squeezing the paper tension unit’s lock tabs gently and pulling the paper tension unit away from the printer. Finally, pull the paper release lever forward to the continuous paper position.

How do I turn off auto tear on Epson LQ 310?

Hold down the Pause button for about three seconds. The Pause light begins flashing and the printer enters the Micro Adjust mode. Press the LF/FF button to feed the paper backward, or press the Load/Eject button to feed the paper forward, until the paper perforation is aligned with the tear-off edge.

Do printers take paper from the top or bottom?

The printer prints on the bottom side of the top sheet of paper loaded in the paper tray. If printing on numbered checks or forms you will need to re-stack the checks or forms in reverse order. When loading the re-stacked checks or forms in the paper tray, place them with the printed side down in the paper tray.

How do I manually put paper in my printer?

Printing using manual feed

  1. Make sure that the product is idle and the Ready light is on.
  2. Access the product Properties dialog box.
  3. Click the Paper/Quality tab.
  4. Select Manual Feed from the Source is drop-down list.
  5. Load paper or an envelope into the priority feed slot, depending on the print job.