How do I fix my Healthometer scale?

How to Reset a Health o meter Scale

  1. Place the Health-O-Meter scale on a flat surface. Make sure the scale is indeed level.
  2. Tap the lower left or right corner of the scale three times. After you do this, you’ll notice the display shows “—.”
  3. Wait a few seconds for the scale to reset and recalibrate.

What does E on Healthometer scale mean?

E. If the device is showing the error “E” on the message screen, check to make sure that you are not moving while calculating the weight. Stand with your back straight, and feet evenly placed on the scale to ensure the most accurate measurement.

Why is my Healthometer scale not working?

Check and make sure the floor where the scale is being used is level. If scale is still reading incorrectly, it may be out of calibration. To double-check take a known weight and place it on the scale to see what it is reading. If the scale is not within tolerance, the scale may need to be calibrated.

How accurate is Healthometer?

A scale is a simple device that has one and only one purpose: to accurately report the weight of an object placed on it. This scale will do that with a margin of error of roughly +/- 20%.

How do you use a Healthometer scale?

How to Set a Digital Health O Meter Scale to 0.0

  1. Remove the shipping plate from the bottom of the scale.
  2. Set the scale to either LBS or KG by adjusting the switch on the back of the Health o meter scale.
  3. Place the scale on a flat surface.
  4. Tap the lower corner of the scale with your foot.

How much weight can a Health o meter scale hold?

350 lb
Health o Meter HDR743 Digital Bathroom Scale, 350 lb Capacity : Health & Household.

How do I clean my Healthometer scale?

Use a mild soap and damp soft cloth. Do not use abrasive or strong chemical cleaners or submerse the entire unit in water. Remove any plastic shipping pins. Allow the scale to reach room temperature.

How do I reset my digital gram scale?

1. Reset unit by pressing ON/OFF button and wait until “0.0” is shown. 2. Press and hold UNITS button for 3 seconds until “CAL” is displayed.