Who makes utilitech sump pumps?

Star Water Systems is recalling about 33,000 sump pumps sold under Utilitech, Do It and Star Water Systems brands due to a fire hazard. According to the Consumer Product Safety Commission, the sump pumps can overheat, posing a risk of fire.

Why does sump pump have 2 plugs?

If you look at the outlet where you sump pump is plugged in, you should see two separate plugs. One is for the float switch, the other is for the motor. Unplug both of them, and then plug in just the one going to the pump. If the pump doesn’t turn on immediately, your pump needs to be repaired or replaced.

Can you use an extension cord with a utility pump?

We recommend the pump be plugged directly into an outlet. If you MUST use an extension cord, it needs to be heavy enough gauge and short enough so that the pump receives full voltage and power.

Why does my sump pump keep breaking?

The most common cause of a sump pump system running continuously is when the sump pump float switch is stuck on the “on” position in your sump pit. This will cause it to run even when all water has been removed, which will burn out the pump prematurely.

How do you adjust the float cord on a sump pump?

Grab the connector that is holding the float to the cord. Squeeze or unfasten the connector with your hands to release it from the cord and adjust it up or down, depending on your needs. The fastening device will depend on your model of sump pump.

What are the two cords on a sump pump?

The first way to test the sump pump is to trace the two electrical cords of the sump pump. The pump cord plugs into the back of the float cord plug. Unplug both cords, then plug only the pump cord into the outlet. The pump should turn on immediately.

Should I unplug my sump pump in the winter?

Never unplug your sump pump. While you might think you don’t need your sump pump over the winter months, you shouldn’t unplug it entirely. If a warm front comes through, snow melts and a rainstorm hits, you might end up with a wet basement all because you forgot to plug your sump pump back in.

Can you plug a sump pump into a surge protector?

Sump Pumps Because most power strips are not designed to be used in damp or wet conditions, they’re unsuitable for use with a sump pump. Instead, plug a sump pump into a GFCI outlet, preferably one installed some height above the floor in case flooding ever does occur.

Can a sump pump be plugged into a power strip?

Because most power strips are not designed to be used in damp or wet conditions, they’re unsuitable for use with a sump pump. Instead, plug a sump pump into a GFCI outlet, preferably one installed some height above the floor in case flooding ever does occur.