How do you reset a Haier washing machine?
How do you reset a Haier washing machine?
If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds. Then, run the rinse/spin cycle without clothing to see if your problems are resolved.
What is FC2 error in Haier washing machine?
FA: water level sensor error. FC0, FC1, or FC2: communication error.
Why does my Haier washing machine keep stopping?
Common solutions for: Haier Washer stops mid cycle If the washer door is not latched shut, the door switch prevents the washer from operating. If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage.
How do I fix error code E21?
Resolution
- Ensure the drain hose is in the correct position.
- Ensure correct drain height.
- Clean the pump and filter.
- Check for a blocked drain.
- Check the drainage hose for possible kink or twist.
- Use less soap powder.
- Switch off the power to the washing machine.
- Contact an Authorised Service Center.
What does fc1 mean on washer?
FC E1 Error Code Power unit down by turning off the circuit breaker or unplugging for one (1) minute. Power unit up by reconnecting power. Restart a new cycle. Monitor the washer for one (1) minute to ensure the error code does not display again.
What does E8 mean on Haier washer?
Haier Combination Washer/Dryer – Error Codes
| Fault Code | Description/Reason |
|---|---|
| E1 | Washer cannot drain the water within 4 minutes |
| E2 | Cannot lock the door after 20 seconds |
| E4 | After 8 minutes, the selected water level has not been reached. |
| E8 | Water level above the warning level |
How do you turn off a lock Haier washer and dryer?
If door to washer/dryer combo door won’t open because it is locked, disconnect power to the unit for 1 minute. Once power is restored, try it again.
How long did it take to fix your haiers washer dryer combo?
I had Haiers 2.0 cubit foot Washer Dryer Combo Unit in white for six months before it broke. It took three months to get it fixed/replaced. The entire process was utterly bizarre, and a small nightmare of customer service insanity.
Why is my Haier washer and dryer combo leaking water?
Haier – Washer/Dryer Combo Leaking If there is water on the floor around the washer/dryer combo:Improperly connected drain hose or water inlet hoses: Check all water and drain connections on the back of the washer/dryer.Plumbing issues: Check for leaking at the water shut-off valves.Drain issues: Make sure the drain hose drains into
Is the GE Haier dryer covered under warranty?
The compressor is covered under 5 yr “sealed system” warranty, but the dryer is not. They can no longer source the dryer part and offered me $150 to buy new one of my choice or a “discounted” rate of $700 for a new GE model. I will never buy another GE Haier model of appliance, because quite simply they do not stand behind their product.
Is the Haier front load DD washing machine any good?
I have purchased a Haier Front load Washing machine with DD motor facility which is wash clothes silently, now I can use my washing machine while my children is sleeping. Thank you Haier. I am happy with Haier front load DD Washing machine. This works great for small loads. The only thing I can think of to improve This works great for small loads.
