How do you clean a EdenPURE 2 filter?

Use a vacuum to remove all dust and debris from the filter and grille. If additional cleaning is necessary, it is safe to run the filter through tap water. However, it is important to note that you should allow the filter to completely air dry before installing back in to your EdenPURE Gen2 heater unit.

Does an EdenPURE heater have a filter?

It is essential to remove and vacuum the rear filter of the heater for optimum performance. You can also rinse your filter carefully under running water and allow to air dry. Ensure the filter is dry before replacing. Make sure the heater rear intake is not blocked or covered.

How do you clean an EdenPURE air filter?

Use a handheld vacuum or vacuum attachment hose to remove large debris from the surface. Wash the filter and screen in warm water to remove particles that were not removed with the vacuum. Use a soft bristle toothbrush for a through cleaning. Dry the filter and screen before replacing into the unit.

How do you troubleshoot an EdenPure heater?

How to Troubleshoot an EdenPure

  1. Check that the EdenPure portable heater is plugged into a reliable, functioning power outlet if the heater turns off, has poor heat output or doesn’t turn on.
  2. Reset the heater’s thermostat if the room isn’t warming sufficiently.

How do I clean my EdenPURE heater?

Pull the filter straight out of the unit by pressing the tab at the top of the filter. Hold the filter with the backside facing up. Run warm tap water over the filter until the filter is clean and the water is clear. The filter can also be soaked in warm sudsy water until clean.

How do I reset my EdenPURE heater?

First, you should unplug the heater’s power cord from the power outlet for at least 30 minutes. This will reset the internal electronics of the EdenPURE 1000 heater. Finally, plug the power cord back in to the power outlet and then, attempt to operate the heater again.

How do I clean the filter on my EdenPURE heater?

How do you reset an infrared heater?

How Do You Reset An Infrared Heater?

  1. The first thing to do is unplug the heater from the electrical outlet.
  2. Next wait for about five to ten minutes for the unit to cool down.
  3. Once cooled down, plug the cord back into the wall socket.
  4. You can now switch the heater on.
  5. The heater should start operating as usual.