How do you configure a VLAN on a Cisco switch?

VLAN Configuration in config-vlan Mode To access config-vlan mode, enter the vlan global configuration command with a VLAN ID. Enter a new VLAN ID to create a VLAN, or enter an existing VLAN ID to modify that VLAN. You can use the default VLAN configuration (Table 12-2) or enter multiple commands to configure the VLAN.

How many VLANs can a 2960 switch support?

4000 VLANs
For example, the Catalyst 2960 and 3560 Series switches support over 4000 VLANs. Normal-range VLANs on these switches are numbered 1 to 1005, and extended-range VLANs are numbered 1006 to 4094.

Which 2960 command assigns a VLAN to an interface?

switchport access vlan [vlan number ] command is used to assign VLAN to the interface.

What are the steps to configure a VLAN on a switch?

First, VLAN support needs to be enabled on the switch if it is not already:

  1. Choose Switch configuration.
  2. Choose Advanced Features.
  3. Choose VLAN Menu…
  4. Choose VLAN Support.
  5. Set Enable VLANs to Yes if it is not already, and choose a number of VLANs.
  6. Restart the switch to apply the changes.

How do you name a VLAN on a Cisco switch?

To name a VLAN on a switch, use the name command in VLAN configuration mode. To set the interface type, use the switchport mode command in interface configuration mode. To set the VLAN when the interface is in access mode, use the switchport access vlan command in interface configuration or template configuration mode.

How many VLANs can be configured on a Catalyst switch?

The device supports VLANs in VTP client, server, and transparent modes. VLANs are identified by a number from 1 to 4094. VLAN 1 is the default VLAN and is created during system initialization. You can configure up to 1024 VLANs on the C9200L and Cisco Catalyst 9200 Series Switches.

How do I add a VLAN to my Cisco router?

To add a VLAN and enter config-VLAN submode on a switch, use the vlan command in global configuration mode. To name a VLAN on a switch, use the name command in VLAN configuration mode. To set the interface type, use the switchport mode command in interface configuration mode.

Where is VLAN setup?

You configure VLANs in vlan global configuration command by entering a VLAN ID. Enter a new VLAN ID to create a VLAN, or enter an existing VLAN ID to modify that VLAN. When you have finished the configuration, you must exit VLAN configuration mode for the configuration to take effect.

How do I assign an IP address to a VLAN?

Assigning a Static Address to a VLAN

  1. In the Mobility Master node hierarchy, navigate to the Configuration > Interfaces > VLANs page.
  2. Under IPv4, select Static from the IP assignment drop-down list.
  3. Enter the IPv4 address of the VLAN interface.