How accurate is UASure?

That’s a precision of 4 to 5%, and the 4 tests through my medical provider matched the test strips to within +/- 0.5.

Is there a self test of uric acid?

The UASure II Blood Uric Acid Test Kit performs a self-test each time it is powered on. For additional accuracy verification, the optional UASure II Control Solution may be purchased.

How accurate are uric acid test strips?

The CVs for the seven lots of strips (lot 1 to lot 7) ranged from 2.93% to 6.33%, 3.2% to 5.9%, 3.64% to 7.0%, 2.84% to 7.6%, 2.68% to 5.42%, 3.03% to 6.93%, and 3.18% to 5.17%, respectively. Conclusion: EasyTouch is an acceptable diagnostic device which provides accurate uric acid measurements.

How do you use UASure?

Instructions

  1. Insert the Battery Into the Back of the Meter With the “+” Facing Towards You.
  2. Insert the Code Chip Into the Side of the Meter.
  3. Prepare the Lancing Device.
  4. Wash Your Hands Thoroughly With a Dish-washing Soap Such as Dawn®.
  5. Make a Fist Ten Times and Shake Your Hand Vigorously in a Downward Motion.

How do uric acid crystals leave the body?

Most uric acid dissolves in the blood, passes through the kidneys and leaves the body in urine.

How long does it take to reduce uric acid levels?

It is thought that it can take up to two years for the body to get rid of all uric acid crystals.

What color is uric acid in urine?

Uric acid kidney stones are often red–orange–brown in color, though uric acid crystals are colorless. The stone color originates from a variety of components in the matrix, some of which are a broad range of urinary pigments or urochrome.

How do you check uric acid levels?

A uric acid test can be done as a blood test or a urine test. During a blood test, a health care professional will take a blood sample from a vein in your arm, using a small needle. After the needle is inserted, a small amount of blood will be collected into a test tube or vial.

How do you use Uritouch?

How to Use Uritouch

  1. Open the back of the meter and insert the battery.
  2. Insert the green chip into the meter.
  3. The device will automatically turn on once you insert a test strip into it.
  4. After inserting the test strip, you should immediately see the tester’s key code.