Which side of Fel-Pro intake gasket goes up?

TOP
TOP or THIS SIDE UP means that’s the side of the gasket that should be facing you once it’s installed. The UP stamp is found on Fel-Pro head gaskets for Subaru engines, which have horizontally opposed cylinders. The edge of the gasket with the UP stamp must be kept up toward the top of the engine block.

Do I use sealant on Fel-Pro gaskets?

Installing Fel-Pro Head Gaskets Use no sealers, adhesives or other additives with these gaskets. Learn more about Fel-Pro quality gaskets that are specifically designed for the repair environment, find your car part, or find where to buy your auto part today.

Do you use sealant on valve cover gaskets?

Valve cover gaskets are designed to seal “dry,” so don’t apply sealant to the face of the gasket. Finish off the job by snugging up the valve cover bolts to the torque specifications in your shop manual.

Do I need to put sealant on head gasket?

If you’re installing one of those old school embossed steel gaskets, you need a sealer to cold seal the engine. But most modern gaskets do not need to be coated with any sealers. And if you’re installing a coated gasket, avoid any chemical seals.

Do you put silicone on both sides of a gasket?

NEVER use silicone on both sides of the gasket, the gasket will slip and slide all over the place instead of staying put and clamping down. Another substitute for the high tack is Copper Coat (in the copper spray can).

Should I use gasket sealer on new gaskets?

There are many different applications and requirements and 1000’s of gasket sealants available. Most of our gaskets do not require sealant. If a solid gasket is being newly fitted to new products/flanges sealant is not necessary.

Does RTV need 24 hours?

However, most gasketing products require 24 hours of cure time. When using RTV gasketing, proper reassembly requires the following: Apply a continuous bead of silicone to the mating surface. Assemble parts with bolts finger tight ensuring contact is established while the silicone is still wet.

Do Felpro valve cover gaskets need sealant?

Fel-Pro gaskets come with retention features in the gasket to help it remain in the cover groove. Some covers use the valve cover bolts/grommets to help hold the gasket in the cover groove. No need for sealers or adhesives to “glue in” the gasket.