What is the minimum height for a main breaker?

The center of the main breaker handle, cannot be higher than 6′ 7″. Check with the local building department, as they may have a minimum height. Practically speaking, you’ll want it at a comfortable height to work in. You’re not going to want to sit, or kneel on the floor while working in the panel.

What is the maximum height for a main breaker panel?

Mounting Height A height limit applies to mounting a panel box. The circuit breaker at the top of the box may not be higher than 6-foot 7-inches from the floor. A permanent platform must be below the panel box if the top circuit breaker exceeds this specific height.

What is the code for electrical panels?

NEC code states that panels must have clearance of 36 inches in front, 30 inches to the sides, and a working area with a clearance of 6 foot 5 inches. You’ll likely need a permit to move an electric panel. A garage or basement is ideal because it meets all these requirements.

Does main breaker have to be on top?

The NEC code provision that a breaker “ON” must be in the up position means that most panels can only use half of the breaker slots if mounted sideways.

How high should a breaker panel be mounted?

The minimum height for a circuit breaker box is 4 feet, though the ideal height is between 5 feet and 6 feet. The maximum height allowed for the circuit breaker box is 6 feet.

Is there a code for electrical outlet height?

Electrical receptacle outlets on branch circuits of 30 amperes or less and communication system receptacles shall be located no more than 48 inches (1219 mm) measured from the top of the receptacle outlet box nor less than 15 inches (381 mm) measured from the bottom of the receptacle outlet box to the level of the …

Can you put the main breaker on the bottom?

Just about all modern electric panels can be mounted upside down, meaning that the main breaker is located at the bottom instead of the top.

Can you put a breaker next to the main breaker?

So in answer to your question no you cannot use this area to add an extra breaker in this space as it goes against the manufacturers installation instructions and might create a fire or shock hazard.