How do you change the filter on a PUR water filter pitcher?

Hold filter under cold running tap water for 10 seconds. Allow excess water to drain. Insert filter into pour tray. Pull filter down while twisting clockwise for a tight seal.

How long do you soak PUR water filter?

Soak it in cold water for 15 minutes. Only use cold water. Using warm or hot water may harm the filter cartridge. After 15 minutes, remove filter cartridge (B) from water and rinse under cold water for 10 seconds.

Do I need to soak my PUR water filter?

Question: Should I soak the filter before use? Answer: PUR PLUS Pitcher with Lead Reduction Filters: Yes, they need to be soaked in cold water for 15 minutes and then held under cold running water for 10 seconds.

How do you open a PUR water pitcher?

Open the swivel filtration system by tilting the filter housing forward, as you would when filtering water. Unscrew the cap at the tip, turning counterclockwise, to reveal the Pur filter. Turn the faucet on. This will eject the filter into the sink.

Does hot water ruin PUR filter?

Yes you can ru hot water through the Pur Filter, however doing so will greatly decrease the life of the filter. Hot water should not be filtered as it is not for drinking-and if for cooking-the high temperatures created via the oven or stove top will kill most any bacteria anyways.

Why is my PUR water filter so slow?

PUR filters may be slow because of air blockages, high sediment levels, hot water or mineral damage, incorrect installation or an old filter. The PUR MineralClear® filter may also result in longer filtration times than the basic filter because of greater contaminant reduction.

What happens if you don’t soak water filter?

If you don’t pre-soak your water filter, you may be using less of the available spaces on the filter, which means the filters lifespan by get prematurely shortened. This can result in slower filtration speeds and means you may have to replace the filter sooner than necessary.

What happens if you don’t flush water filter?

Weird Taste or Smell If you drink your water without flushing it you might notice a funny taste or smell right away. This is most likely a result of the same two causes above. If there’s a high amount of carbon bits, that could definitely affect the taste.