What power supply do I need for 12V LED lights?

If you have an LED strip with 12-volt DC operation that you wish to use in a 120-volt AC home wiring system, you’ll need a power supply that includes 120 volts in its input range and has 12-volt DC output.

How many LED can a 12V power?

Since the LEDs are in series, they all have the same current through them, and will therefore have the same brightness. To answer the question otherwise, do the math. You have a 12 V supply and each LED might need up to 3.5 V. (12 V)/(3.5 V) = 3.4 LEDs max.

Is LED driver same as LED power supply?

LED power sources that provide a “constant-current” output have typically been referred to as LED drivers. In the past, AC-DC power supplies that provided a regulated “constant-voltage” to LEDs were referred to as LED power supplies. Today, the terms “LED driver” and “LED power supply” are used interchangeably.

How many amps do 12V LED lights draw?

With 12V systems, the lower voltage means more current must be supplied to compensate. For example, a 120V LED system will pull 1 Amp in a 120 Watt system, while a 12V LED system will need to pull 10 Amps to power the same 120 Watt system.

Do 12V LEDs need resistors?

LEDs can be ran off multiple voltages, but a series resistor is required to limit the current in the circuit. Too much current in an LED will destroy the device. As with all diodes, LED’s will only allow current to flow in the direction from the anode to the cathode.

Do I need a resistor for LED?

Resistors in Light Emitting Diode (LED) Circuits Such a resistor is often called a ballast resistor. The ballast resistor is used to limit the current through the LED and to prevent excess current that can burn out the LED. If the voltage source is equal to the voltage drop of the LED, no resistor is required.

Will 12V DC LEDs work on 12V AC?

I’ve run 12″ single color LEDs on 12VAC with no problem.

Is there a difference between 12V AC and 12V DC?

12V DC is safer than 12V AC. Body resistance decreased when the 12V AC still may cause the dead, 12V DC will not be in 100%. However, the hazard degree of electric shock to the human body mainly depends on the size of the current passing through the human body and the length of the energization time.

Can I use a LED power supply?

As long as the output voltage and current match, you should be good to go.