How do you use a Siemens digital thermostat?

How to Set a Siemens Thermostat

  1. Locate the “Mode” switch on the front of your Siemens thermostat.
  2. Rotate the “Set Point Adjuster” knob on the thermostat to set the appliance to the desired temperature.
  3. Set the fan speed for your thermostat.

What is Siemens thermostat?

Easy to use and install, this Siemens wireless programmable room thermostat and receiver is a high quality digital heating control that’s perfect for everyday use. With a 20-metre range between the transmitter and the receiver, your customer can control their central heating system from almost anywhere in the home.

Why is my Siemens thermostat not working?

Siemens Thermostat RDJ10/RDJ10RF Not Working Loosen the thermostat screw which holds it to the wall and take it to the boiler. On the wall unit next to your boiler, you can see buttons “Set” and “Reset”. Press and hold the reset button for approximately four seconds until the orange light begins to flash.

How do I change the battery in my Siemens thermostat?

Changing the batteries 1. Get two new batteries of type AA alkaline, 1.5 volts. 2. Within one minute: pull out the battery compartment and remove the batteries, then insert new batteries and replace the battery compartment.

How does Siemens room thermostat work?

The Smart Thermostat detects when a resident enters a room and switches from “Away” to “Home” mode. Even if the user is outside the detection area, the Smart Thermostat will not switch off.

How do you reset the thermostat on a receiver?

A common way to reset almost any thermostat is to hold down the reset button for 5+ seconds. Alternatively, try resetting battery-powered thermostats by flipping the battery directions around for 5s, then flip them back. If all else fails, switch off the power at the circuit breaker for a couple minutes.