How do I connect to Linksys WAP54G?

Connect to a Router

  1. Connect the Linksys WAP54G device to your Internet modem using the Ethernet cable.
  2. Type “admin” — without quotation marks — in the password field. Leave the user name blank. Click “OK” to access the WAP54G setup page.

How do I setup my Linksys AC1200?

This article provides instructions on how to do it.

  1. Plug the Linksys WAP1200AC into a wall outlet.
  2. Connect a wireless computer or a mobile device to Linksys AP Setup – xxx which is the Linksys WAP1200AC’s default SSID.
  3. Open a web browser and enter http://ap.linksys.com or 192.168.
  4. Click Start Setup.

How do I use my Linksys WAP54G as a wireless repeater?

Linksys Wireless-G Router (WRT54G)…Configuring an Access Point as a wireless repeater

  1. Access the router’s web-based setup page.
  2. When the router’s web-based setup page opens, click Status then click Wireless.
  3. Take note of the MAC Address.
  4. Connect a computer to the access point.
  5. Assign a static IP address on the computer.

What is the default IP of Linksys WAP54G?

192.168.1.245
This article will guide you on how to check and configure the IP address of your Linksys wireless access point. The default IP address of a WAP54G is 192.168. 1.245 and the Configuration Type is Static IP.

How do I reset my Linksys WAP54G?

How to Reset a WAP54G Password

  1. Take a small paperclip and bend one end of it so that it’s straight.
  2. Locate the reset button on the back of the router.
  3. Release the button and wait until the lights stop blinking while the access point resets itself.

Can I use my old Linksys router as a repeater?

If the router’s wireless signal is not reaching all areas of the office, you may want to consider extending it by adding another Linksys router. Put the second router into repeater mode and it will connect to the primary router’s signal, extending the network to other areas.