How do I take pictures at night with my Sony Cybershot?

Set Self-Timer to 2sec to shoot without blurring. Select this to shoot clear night scenes using a tripod. This sets a low ISO sensitivity to reduce noise, and it uses a slow shutter speed to brighten the image. NOTE: Camera shake may occur when pressing the shutter button, even when using a tripod.

How can I take night shots without noise?

Increase Your ISO When shooting at night, your eyes naturally adjust to the darkness and allow you to see. The LCD screen on the back of your camera, however, is made up of light bulbs. It’s bright! This leads photographers to think the image they are capturing is far brighter than the file actually is.

How do I take a picture of the moon with my Sony Cybershot?

Aperture: Set your aperture to f/11. Shutter Speed: Set your shutter speed to 1/100. White Balance: Set it to “Daylight”, although it does not matter if you shoot in RAW – you will be able to change it in post-processing. Lens Focus: Use the rear LCD screen of your camera to zoom in and focus on the moon.

How do I change the shutter speed on my Sony DSC HX80?

Digital Still Camera DSC-HX80

  1. Set the mode dial to M (Manual Exposure).
  2. Press the bottom side of the control wheel to select the shutter speed or aperture value, then turn the control wheel to select a value.
  3. Adjust the focus and shoot the subject.

How do I set the timer on my Sony Cybershot camera?

Shoots an image using the self-timer after a designated number of seconds have elapsed since the shutter button was pressed. MENU → (Camera Settings) → [Drive Mode] → [Self-timer]. Select the desired mode using the right/left side of the control wheel.

How do I turn the flash on my Sony Cybershot?

The manual reads:

  1. Press the flash unit pop-up button to raise the flash. When the flash unit is not raised, the flash mode is set to (Off) automatically. You cannot change the setting.
  2. Press (Flash) on the control button.
  3. Select the desired mode with the control button.