How do I drain the water from my Bosch dryer?
How do I drain the water from my Bosch dryer?
Bosch and Siemens heat pump dryer
- Detach the existing hose from the connector and connect it to the holder.
- Connect the included drain hose to the freed-up connector.
- Remove the filter from the holder in the condensation water reservoir.
- Place the filter in the slot at the top of the reservoir.
How do I reset my Bosch Axxis dryer?
Locate the small red reset button above the heating element and press and hold the button for a few seconds. Release the button.
Why is my Bosch condenser dryer not collecting water?
Start by unplugging the appliance and removing the condenser tray to allow you to clean the area. Try to reach into the slot that the tray is connected to and clean as much debris as possible. Use a dry cloth to clean as much of the area as possible and clean out the condenser tray under the sink.
Why is my Bosch washer not draining?
A Bosch washer not draining properly is often due to a drain hose obstruction. The drain hose transports water as it flows through the drain pump to the sink or standpipe. Blockages are often due to kinks in the hose or clogs formed by lint, debris or foreign objects that restrict water flow.
Where is moisture sensor in Bosch dryer?
To clean the moisture sensor, wipe it down with a damp cloth and a little bit of white vinegar. The sensor is located next to the lint filter.
Where is the moisture sensor on a Bosch dryer?
How do you clean a Bosch tumble dryer condenser?
5. Clean your dryers condenser / heat exchanger
- Let the dryer cool down and put an absorbent cloth under the service door before putting out the condenser.
- Flush the heat exchanger of all sides with a water jet to completely remove all lint.
- Remove all lint from the seals on the dryer and heat exchanger.
Where is the reset button on a dryer?
Often, dryers are equipped with a reset button on the control panel. If the motor won’t run, let the dryer cool for about ten minutes. Then press this reset button.
Why is there water underneath my dryer?
Blocked ventilation is often the reason why a dryer is leaking water. The dryer works by heating air and distributing it around the drum to dry the clothes. If the dryer is unable to vent the warm air, it condenses and causes water to collect in the dryer.
