Do High Lift mower blades cut better?

High lift blades are known for bagging and discharging clippings more effectively due to the extra airflow they create, and they also help you to get a more level cut a lot of the time.

Which way do John Deere mower blades go on?

Most lawn mower blades rotate in a clockwise direction (counter-clockwise when viewed from below), and as such have the cutting edge on the right side. If you are unsure of how your mower rotates, check the position of the discharge chute; if it is on the right side angled back, the blade turns clockwise.

Are John Deere mower blades reverse thread?

Are John Deere Mower Blades Threaded in Reverse? No. The bolt that holds John Deere mower blades in place is threaded in the usual fashion. To tighten it you simply turn it to the right, (clockwise) like you would any standard bolt.

How sharp should mower blades be?

How Sharp Should Your Mower Blade Be? Mower blades should be aggressively sharp, but not as sharp as a razor’s edge. You should be able to touch the blade with your hand without getting cut. Contrary to popular belief, a lawn mower blade with a razor sharp edge will not cut grass better.

What is the point of high lift mower blades?

High-lift blades have deeper curves on the ends, which create enough suction to circulate and expel the clippings. The higher air flow also helps prevent clogging when mowing tall or wet grass. A high lift blade is a unique style of blade designed with larger wind wings which increase airflow.

What happens if you install mower blades upside down?

But what you’ll notice if you install this blade the wrong way round is that the quality of the cut your mower gives you actually gets a lot worse. And that makes a lot of sense, because it’s now using the blunt edge to cut the grass (well, more like hack).

Which side of mower blade faces down?

To determine which side of your lawn mower blade is up, first figure out which side is the sharp cutting edge, and which side is the blunt edge. Look for a sticker indicating which side goes up and which side faces downward. The cutting edge should face the grass while the dull edge should face the deck of the mower.